ASRock X58 SuperComputer Motherboard

برای مشاهده این لینک/عکس می بایست عضو شوید ! برای عضویت اینجا کلیک کنید


برای مشاهده این لینک/عکس می بایست عضو شوید ! برای عضویت اینجا کلیک کنید


برای مشاهده این لینک/عکس می بایست عضو شوید ! برای عضویت اینجا کلیک کنید

f you don't have XMP Memory you can manually select your memory speed from the available options of DDR3 800, DDR3 1066, DDR3 1333, DDR3 1600, DDR3 1866 and DDR3 2133 and then go in and set up your memory speeds. It's nice that ASRock has provided such a wide range of memory multipliers on this board so that you can crank up your fast memory kit without pushing your entire system into the realm of instability.

ASRock has played nice with overclockers as they offer a full spectrum of voltage adjustments and a wide range to play with. You can certainly damage your hardware with the range they give you so make sure you pay attention to the warnings and take baby steps when tweaking.

* CPU Voltage -=- 0.84375v-1.6v in 0.00625v increments
* DRAM Voltage -=- 1.53v-2.451v
* DRAM CTRL Ref Voltage -=- -0.06741v- +0.08v
* DRAM DATA Ref Voltage -=- -0.06741v- +0.08v
* IOH Voltage -=- 1.1v-1.49v
* VTT Offset Voltage -=- +0mV-300mV in 100mV increments
* ICH Voltage -=- 1.12v-1.56v in 0.02v increments
* IOH CSI Voltage -=- 1.12v-1.56v in 0.02v increments
* IOH/ICH PCIe Voltage -=- 1.52v-1.9v in 0.02v increments
* CPU PLL Voltage -=- 1.82v-2.50v in 0.02 increments


Overclocking:

Most of the overclocking results have been documented in our Core i7 920 CPU review over here. Just like in the EVGA X58 3X SLI motherboard review, we tried to max out the bus and reduce the multiplier in order to achieve the highest bus possible. We found our bus speed results to be exactly the same as with the EVGA board so this concludes a bit of our suspicion that the CPU is limiting our bus overclocks. We still managed to get to 214MHz stable and tweaked out at 220MHz with about 98% stability. Better cooling or a little more voltage might have made this stable, but we were pushing the voltages a bit as it was. In order to get our CPU stable, we had to run the CPU voltage at 1.47v in order to keep it up around 1.4v.


برای مشاهده این لینک/عکس می بایست عضو شوید ! برای عضویت اینجا کلیک کنید

برای مشاهده این لینک/عکس می بایست عضو شوید ! برای عضویت اینجا کلیک کنید

برای مشاهده این لینک/عکس می بایست عضو شوید ! برای عضویت اینجا کلیک کنید

http://www.bcchardware.c


om/index.php?option=content&task=view&id=7199&Itemid= 40&limit=1&limitstart=6